Sun-microsystems X4150 Manuel d'utilisateur télécharger pdf (Page 23)

Chapter 2 Installing the Sun Fire X4150 Server Into a Rack with Slide-Rails 13

Installing the Mounting-Brackets Onto the Server

To install the mounting-brackets onto the sides of the server:

1. Position a mounting-bracket against the chassis so that the slide-rail lock is at

the server front, and the three keyed openings on the mounting-bracket are

aligned with the three locating pins on the side of the chassis.

FIGURE 2-2 Aligning the Mounting-bracket With the Server Chassis

2. With the heads of the four chassis locating pins protruding though the four

keyed openings in the mounting-bracket, pull the mounting-bracket toward the

front of the chassis until the mounting-bracket clip locks into place with an

audible click. (See

FIGURE 2-2.)

3. Verify that the rear locating pin has engaged the mounting-bracket clip. (See

FIGURE 2-2.)

4. Repeat to install the remaining mounting-bracket on the other side of the

server.

Chassis front

Slide-rail lock

Mounting-

Mounting-bracket

bracket clip

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 81 82

Pas de commentaire

Sun-microsystems X4150 Manuel d'utilisateur Page 23