Sun Microsystems X2250 Manuel d'utilisateur télécharger pdf (Page 72)

4-24 Sun Fire X2250 Server Service Manual • April 2009

FIGURE 4-21 Installing the Power Supply

4. Connect three of the power supply cables to the motherboard. See FIGURE 4-38.

5. Reinstall the cable clips to the power supply cables.

This ensures that the power supply cables will not obstruct the CPU airstream.

6. Perform the following procedures to reconnect the power supply to the hard

disk drives (HDDs).

a. Squeeze the tabs on the connector and push it through the cut out in the

chassis bulkhead.

a. Reconnect the HDD power harness plug to the power supply unit.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 133 134

Sun Fire 1
X2250 Server 1
Service Manual 1
Contents 3
Contents v 5
Contents vii 7
Index Index–1 8
How This Book Is Organized 9
Typographic Conventions 10
Support and Training 11
Product Updates 11
Third-Party Web Sites 11
Warranty 12
Sun Welcomes Your Comments 12
1.1 Features 14
1.2.1 Preinstalled Software 15
1.3 Hardware System Overview 16
1.3.2 Internal Components 17
Processor Configuration 19
FIGURE 1-1 20
1.4.4 Clearing the CMOS 21
Troubleshooting 23
2.1 Troubleshooting Overview 24
Chapter 2 Troubleshooting 2-3 25
Troubleshooting Procedures 26
Chapter 2 Troubleshooting 2-5 27
Problem Possible solution 28
Chapter 2 Troubleshooting 2-7 29
Performing Diagnostics 31
Option Description 33
Diagnostics Tests menu 34
3.3.1 Testing the Hard Disk 36
3.4 Immediate Burn-in Testing 37
3.5 Deferred Burn-in Testing 39
■ Select Yes and press Enter 42
Solaris 10 Operating System 45
3.7 Show Results Summary 46
3.8 Print Results Report 48
3.9 About Pc-Check 48
3.10 Exit to DOS 48
4.1 Tools and Supplies Needed 49
4.2 Installation Precautions 50
FIGURE 1-2) 51
Removing the Server Cover 52
2 CPU 1 10 Dual blower module 53
5 DIMM slots (4) 13 I/O board 53
4.5.1 Replacing the I/O Board 55
Installing the I/O Board 56
35W cards 57
FIGURE 4-6 58
FIGURE 4-7 58
Removing a PCIe Card 59
Installing the PCIe Card 60
Removing a Hard Disk Drive 61
Installing a Hard Disk Drive 62
Carrier” on page 4-14 65
Removing the ODD Filler Panel 67
4.5.6 Replacing the Air Duct 68
To install the air duct: 69
, aligning the baffle 69
Installing the Air Duct 70
Removing the Power Supply 71
Installing the Power Supply 72
Removing the Fan Module 73
Installing the Fan Module 74
4.5.10.2 Removing a DIMM 77
Bank 1 DIMM Slot Locations 78
4.5.10.3 Installing a DIMM 79
Installing a DIMM 80
FIGURE 4-30 for the 81
Removing the System Battery 82
Installing the System Battery 83
FIGURE 4-32) 84
Removing a Heatsink 85
Removing the CPU 86
Installing the CPU 87
FIGURE 4-35 88
4.5.13 Installing a New CPU 89
Installing the Heatsink 91
4.5.14 Replacing Cables 92
4.5.15 Motherboard 93
Removing the Motherboard 94
Installing the Motherboard 95
7. Replace the system cover 96
System Specifications 99
A.2 Power Specifications 100
TABLE A-6 101
B.2 Updating BIOS 104
B.3 Updating SP Firmware 106
B.3.2 ILOM Web Interface 107
PXE Server 109
# unzip syslinux-3.09.zip 110
# cd /syslinux-3.09/memdisk 110
Sun Fire X2250 Server 112
Mainboard is Replaced 113
With Optional Slide Rails 115
Installation 116
FIGURE C-2.) 117
FIGURE C-3.) 118
FIGURE C-4.) 119
Setting the Rail Width 120
Rail-width spacer 120
Assemblies 121
FIGURE C-6.) 122
FIGURE C-6.) Continue 122
Assembly 123
CMA rail 124
Left slide-rail 124
Left slide rail 125
Right slide rail 126
CMA mounting 126
CMA slide-rail 127
Right slide 127
CMA extension 128
CMA arm connector 128
(on left slide rail) 128
Installing CMA Cable Hangers 129
CMA cable hanger 129

Commentaires sur ces manuels

Pas de commentaire

Sun Microsystems X2250 Manuel d'utilisateur Page 72

Commentaires sur ces manuels

Produits connexes et manuels pour Le serveur à l'état brut Sun Microsystems X2250