Sun-microsystems Ethernet MMF/UTP Adapter Manuel d'utilisateur télécharger pdf (Page 106)

72 Sun PCI-Express Dual Gigabit Ethernet MMF/UTP Adapter Installation and User’s Guide • June 2006

Using the OpenBoot PROM FCode Self-

Test

The Sun PCI-Express Dual Gigabit Ethernet Low-Profile adapter self-test is a suite of

tests that reside in the adapter’s FCode PROM.

You can only invoke the FCode self-test diagnostics using the OpenBoot PROM

test or test-all commands. In order to access the OpenBoot PROM, you must

shut down and halt your system to display the ok prompt.

You can use the adapter’s self-test any time you want to determine the status of the

hardware. If you encounter an error while running the diagnostic test, the self-test

displays appropriate error messages.

Note – Although the self-test does not require the adapter’s interface to be

connected to an active network, you will see failing error messages if it is not

connected.

▼ To Run the FCode Self-Test Diagnostic

For more information about the OpenBoot commands (including test) in this

section, refer to the OpenBoot Command Reference manual.

1. Before shutting down the OS and halting the system, ensure that all significant

application and network activity on the server has stopped.

2. Follow the appropriate procedures, as documented in the system’s service manual,

to shut down and halt the system.

Refer to the system’s documentation for the complete shutdown procedure.

After shutting down the system, you should see the OpenBoot PROM’s ok prompt

on the system console.

3. At the ok prompt, set the auto-boot? configuration variable to false.

ok setenv auto-boot? false

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 121 122

Pas de commentaire

Sun-microsystems Ethernet MMF/UTP Adapter Manuel d'utilisateur Page 106