Sun-microsystems 2000E Manuel d'utilisateur télécharger pdf (Page 40)

2-24 SPARCserver2000E Power SupplyInstallationManual—April1995

Note – The following screen display is an example only. The actual message

displayed on the screen will vary with the software running on the system.

Note – When a system is started for the first time, or if the master board is

replaced, OBP will prompt you to select a system board to be the new system

master. The system master is normally in slot 0.

If there is no terminal on this system, you must check the system status by

inspecting LEDs on the front panel and if present) on the power supply

adapter board. See Figure 2-22 and Figure 2-23.

Table 2-1 summarizes LED status conditions during and after POST.

Figure 2-22 Front Panel Status LEDs

<<<< SPARCsystem 2000XX POST VX.X >>>>

...(various test messages)...

SPARCsystem 2000 Series (2 X XXXXXX), No Keyboard

ROM Rev. -.-, --- MB Memory installed, Serial #---.

Ethernet address -:-:--:-:--:--, Host ID: ------.

DC power (green)

Fault (yellow)

System running (green)

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 53 54

Pas de commentaire

Sun-microsystems 2000E Manuel d'utilisateur Page 40