Sun Microsystems CP3220 Manuel d'utilisateur Page 93
- Page / 135
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Chapter 4 Configuring and Using BIOS Firmware 4-15
4. On the Boot Settings Configuration screen (FIGURE B-17), you can enable or
disable the options shown in
TABLE 4-2
TABLE 4-2 POST Options
Option Description
Quick Boot This option is disabled by default. If you enable Quick Boot, the BIOS skips certain tests
while booting, such as the extensive memory test. This decreases the time it takes for the
system to boot.
Quiet Boot This option is disabled by default. If you enable this, the Sun Microsystems logo is
displayed instead of POST codes.
AddOn ROM
Display Mode
This option is set to Force BIOS by default. This option has effect only if you have also
enabled the Quiet Boot option, but it controls whether output from the Option ROM is
displayed. The two settings for this option are as follows:
• Force BIOS – Remove the Sun logo and display Option ROM output.
• Keep Current – Do not remove the Sun logo. The Option ROM output is not displayed.
Bootup Num-Lock This option is On by default (keyboard Num-Lock is turned on during boot). If you set
this to Off, the keyboard Num-Lock is not turned on during boot.
PS2 Mouse Support This option is set to On by default. Select this option for PS/2 mouse support.
Wait for ‘F1’ If Error This option is disabled by default. If you enable this option, the system will pause if an
error is found during POST and will resume only when you press the F1 key.
Hit ‘F2” Message This option is enabled by default. If you disable this option, the system will not display
the “Press DEL to run Setup” messages in POST.
Interrupt 19 Capture This option is reserved for future use. Do not change.
Show Extended
System Information
This option is disabled by default. If you enable this option, the systems shows the
extended system information at the end of POST and before the operating system takes
control.
- Sun Netra 1
- CP3220 Blade Server 1
- User’s Guide 1
- Contents 3
- ▼ To Install an ARTM 10 4
- Contents v 5
- ▼ Viewing OOS LED Settings 34 5
- ▼ Setting OOS LED Behavior 35 5
- Contents vii 7
- Figures xi 11
- Using UNIX Commands 16
- Shell Prompts 16
- Typographic Conventions 17
- Related Documentation 17
- Third-Party Web Sites 18
- Sun Welcomes Your Comments 18
- Introduction 19
- 1.1 Overview 20
- 1.2 Features 20
- 1.3 Physical Description 21
- Figure Leg end 22
- Chapter 1 Introduction 1-5 23
- 1.3.2 Blade Server Diagram 24
- 1.4 System Configurations 25
- FIGURE 1-6) 26
- Chapter 1 Introduction 1-9 27
- TABLE 1-1. Sun 28
- I/O Configurations 29
- 1.5 Hot-Swap Support 30
- 1.6 System Components 30
- 1.6.3 Software Components 31
- Information 32
- Chapter 1 Introduction 1-15 33
- ■ A ground mat 36
- Requirements 38
- ▼ To Install an ARTM 44
- FIGURE 2-2) 46
- The tip utility 48
- The minicom utility 48
- Solaris OS 49
- 2.3 Service Procedures 51
- 2.3.4 Powering On the System 52
- 2.3.6 Servicing DIMMs 53
- FIGURE 2-4 for DIMM 55
- FIGURE 2-5) 55
- 2.3.6.3 Removing a DDR2 DIMM 56
- Removing a DIMM 57
- FIGURE 2-7) 58
- Compact Flash Location 59
- FIGURE 2-8 60
- Removing an AMC Filler Panel 61
- Installing an AMC Card 62
- Pin Number Purpose 64
- ▼ Viewing OOS LED Settings 68
- ▼ Setting OOS LED Behavior 69
- Reset button 70
- Software Configuration 71
- 3.1 Operating Systems 72
- 3.2 Software Updates 72
- 3.3 SunVTS Software 73
- Behavior 75
- Data Bytes 76
- Configuring and Using BIOS 79
- Firmware 79
- 4.1 About BIOS Settings 80
- BIOS Setup Screens Summary 81
- Menu Item 82
- Setup Screens 83
- FIGURE 4-4) 87
- Change Password Menu 88
- FIGURE 4-5) 89
- 4.7 Updating the BIOS 90
- 4.8 Secondary BIOS Image 90
- 4.11 Power-On Self-Test 92
- 4.12 Changing POST Options 92
- POST Options 93
- Hardware Architecture 95
- 5.1 Block Diagram 96
- 5.2 The AMD Opteron Processor 97
- 5.3 Memory 98
- 5.4 Networking and I/O 99
- 5.4.2 PCI Express Bus 100
- 5.4.3 Dual BIOS 100
- 5.5 I/O Components 101
- 5.5.3 SAS/SATA 102
- Physical Characteristics 103
- A.2 Power and Thermal Metrics 104
- A.1 Form Factor 104
- Airflow Requirements 105
- ARTM Pressure Drop 105
- A.3 Connectors and Pinouts 106
- A.3.1.2 USB Ports 107
- A.3.2 AMC Connectors 108
- Pin Number Name Description 109
- Zone 2 Connector 111
- (Zone 3) 112
- J31 Connector Pin Assignments 113
- J32 Connector Pin Assignments 114
- J33 Connector Pin Assignments 114
- BIOS Screens 115
- FIGURE B-1 BIOS Menu Tree 116
- BIOS Main Menu 117
- Advanced Configuration Menu 117
- CPU Configuration Menu 118
- IDE Configuration Menu 118
- Super IO Configuration Menu 119
- ACPI Settings Menu 119
- Event Logging Details Menu 120
- MPS Configuration Menu 120
- SMBIOS Configuration Menu 121
- USB Configuration Menu 122
- Appendix B BIOS Screens B-9 123
- Boot Settings Menu 124
- Boot Device Priority Menu 125
- Security Settings Menu 126
- Change Password Settings Menu 126
- Chipset Main Menu 127
- Appendix B BIOS Screens B-15 129
- Exit Options Menu 130
- Appendix B BIOS Screens B-17 131
Produits connexes et manuels pour Serveurs Sun Microsystems CP3220
(60 pages)
(68 pages)© 2020, manymanuals.fr. Tous droits réservés | 2.678 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels