Sun Microsystems CP3220 Manuel d'utilisateur télécharger pdf (Page 37)

Chapter 2 Hardware Installation and Service 2-3

The grounded mat or the chassis must be connected to a facility ground to

prevent a floating ground.

■ Keep blade servers in the antistatic bags until they are needed.

■ Remove a blade server from its antistatic bag only when wearing a properly

connected ground strap.

■ Place blade servers that are out of their antistatic bags on an antistatic mat if one

is available and the mat is grounded to a facility electrical service ground. Do not

place blade servers on top of an antistatic bag unless the outside of the bag also

has antistatic protective properties.

2.1.2 Materials and Tools Required

The tools required for installation and service are:

■ Phillips screwdrivers: No. 1 (required), No. 2 (optional)

■ Antistatic wrist strap

■ Terminal console

■ Serial cable of less than 10 meters in length to connect the Sun Netra CP3220

blade server with a system console

Refer to Section 1.6, “System Components” on page 1-12 for information on

hardware requirements.

2.2 Installing the Blade Server

2.2.1 Preparing for the Installation

Prepare for installation by reading and performing the following steps.

1. Become familiar with the contents of the documentation referenced in the steps.

2. Verify that all listed hardware and software are available (see Section 1.6, “System

Components” on page 1-12).

3. Check power, thermal, environmental, and space requirements (see

Section 2.2.1.1, “Check Power, Thermal, Environmental, and Space Requirements”

on page 2-4).

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 134 135

Pas de commentaire

Sun Microsystems CP3220 Manuel d'utilisateur Page 37