Sun-microsystems FASTETHERNET 6U Manuel d'utilisateur télécharger pdf (Page 101)

Appendix D Testing the Adapter 83

The following tests are run when you execute the test command:

■ HME register

■ MAC internal loopback

■ 100 Mbps PHY loopback

■ 10 Mbps PHY loopback

Note – To test all of the interfaces of the adapter, you will need to execute the test

command separately for each SUNW,qfe interface.

If all of the tests pass, you will see these messages:

If the adapter’s interface is not connected to a network, you will see the following

error messages:

Note – If the test command fails, verify that the adapter hardware is installed

correctly and the Ethernet device is connected to an active network. If necessary,

replace the adapter or contact your service provider for support.

8. After testing the adapter, type the following commands to return the OpenBoot

PROM to the standard operating mode.

ok test /pci@1f,0/pci@1/pci@1/pci@d/SUNW,qfe@3,1

Hme register test --- succeeded.

Internal loopback test -- succeeded

Transceiver check -- Using onboard transceiver -- Link up passed

ok test /pci@1f,0/pci@1/pci@1/pci@d/SUNW,qfe@3,1

Hme register test --- succeeded.

Internal loopback test -- succeeded

Transceiver check -- Using onboard transceiver -- Link down

Autonegotiation timeout

Check Cable or contact system administrator

Failed

selftest failed. return code = -1

ok setenv diag-switch? false

ok setenv auto-boot? true

1 2 ... 96 97 98 99 100 101 102 103 104 105 106

Pas de commentaire

Sun-microsystems FASTETHERNET 6U Manuel d'utilisateur Page 101