Sun-microsystems VIRTUALBOX VERSION 3.1.0_BETA2 Manuel d'utilisateur Page 152

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 283
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 151
9 Advanced topics
dmidecode -t0
and the DMI system information can be obtained with
dmidecode -t1
9.16 Configuring the guest time stamp counter (TSC)
to reflect guest execution
By default, VirtualBox keeps all sources of time visible to the guest synchronized to a
single time source, the monotonic host time. This reflects the assumptions of many
guest operating systems, which expect all time sources to reflect “wall clock” time. In
special circumstances it may be useful however to make the TSC (time stamp counter)
in the guest reflect the time actually spent executing the guest.
This special TSC handling mode can be enabled on a per-VM basis, and for best
results must be used only in combination with hardware virtualization. To enable this
mode use the following command:
VBoxManage setextradata "My VM" "VBoxInternal/TM/TSCTiedToExecution" 1
To revert to the default TSC handling mode use:
VBoxManage setextradata "My VM" "VBoxInternal/TM/TSCTiedToExecution"
Note that if you use the special TSC handling mode with a guest operating system
which is very strict about the consistency of time sources you may get a warning or
error message about the timing inconsistency. It may also cause clocks to become
unreliable with some guest operating systems depending on they use the TSC.
9.17 Configuring the hard disk vendor product data
(VPD)
VirtualBox reports vendor product data for its virtual hard disks which consist of hard
disk serial number, firmware revision and model number. These can be changed using
the following commands:
VBoxManage setextradata "My VM"
"VBoxInternal/Devices/ahci/0/Config/Port0/SerialNumber"
"serial"
VBoxManage setextradata "My VM"
"VBoxInternal/Devices/ahci/0/Config/Port0/FirmwareRevision"
"firmware"
VBoxManage setextradata "My VM"
"VBoxInternal/Devices/ahci/0/Config/Port0/ModelNumber"
"model"
152
Vue de la page 151
1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 282 283

Commentaires sur ces manuels

Pas de commentaire