Sun-microsystems SunSwift SPARCcenter 2000 Manuel d'utilisateur télécharger pdf (Page 21)

InstallingtheAdapter 2-5

2.5 Post-InstallationProcedures(Optional)

Perform the following tasks to verify and customize the performance of the

SunSwift SBus Adapter.

2.5.1 Watching Network Activity

Make sure that you are connected to an active network.

♦ You can watch network activity or incoming network packets by typing

the following:

Note – The network speed is the same as the speed of the hub to which your

system is connected. See Section 2.5.3 “Auto-Negotiation” and Section 2.5.4

“Configuring Driver Parameters” for information on speed selection.

2.5.2 Running Diagnostics

Refer to the SunVTS 1.0 User’s Guide document for diagnostic tests for the

SunSwift SBus Adapter.

ok watch-net-all

/iommu@f,e0000000/sbus@f,e0001000/SUNW,hme@0,8c00000

hme register test -- succeeded.

Internal loopback test -- succeeded.

Transceiver check -- Using Onboard Transceiver, 100 Mbps Link

Down, 10 Mbps Link Up, passed

Using Onboard Transceiver, 100 Mbps Link Down, 10 Mbps Link Up,

Looking for Ethernet packets.

'.' is a good packet. 'X' is a bad packet.

Type any key to stop.

...........

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Pas de commentaire

Sun-microsystems SunSwift SPARCcenter 2000 Manuel d'utilisateur Page 21